Quote:
Originally Posted by alstensby
So I looked down while washing my bike today and notice there's a wire hanging there. Turns out, the integrated LED brake light/turn signal (left) and my left bullet marker are MIA. Looking under there, it's a bit of a mess. Doesn't help that I'm not the best when it comes to the electronics. (previous owner did this) So...anyone have this set up and can either walk me through it or show me the proper way to have it hooked up? Right now, I found a connection that gets them to blink, but all three for the left (both rear and the one in front) are blinking too fast...still at the speed indicating a light is out. But, all three light. So...something's wrong. Any help?
|
You need an electronic flasher or a load equalizer for LED's. If you have leds in the front, then you will need a diode from Kury as well.