[CRAZYTasty]

Hello, it's been a while since my last few posts. I've just recently
found time again to devote to the project bike. Since I last posted I
have rebuild and bench synch'ed the carbs, cleaned and freed the clutch
assembly and rewired most original harness including installing a dyna s ignition.
My focus is now on adjusting the valves. The bike runs ok now (idle and midrange
are no longer an issue) but the bike breaks up past mid throttle.
My question is what tools / gaskets / parts am I going to need to make this
valve adjustment as painless as possible? I have also looked into possibly
replacing the oil pressured-activated cam chain tensioner with the manual
adjust type, any thoughts?