Quote:
Originally Posted by Chondro
I am getting ready to install my new Cobra light bar on my 2008 900 classic LT. I want the lights to operate exactly like Freightshaker's video: On with headlight, high or low, and switchable off using the stock Cobra switch.
I've read this entire thread three times and I think I understand most of it. I am going to use Kevin's instructions from page 7.
Shopping list:
12 v relay
bullet connectors for aux hot and ground leads in can
spade connectors for relay tabs
I understand the connections for pins 30, 85, and 87.
Pin 86: I understand finding the blue/yellow wire on my 900 but am confused about the the diagram in Kevin's post on page 7. The diagram seems to show a switch and fuse. Is this the Cobra switch? Do I have to buy a fuse and holder and install myself in the pin 86 line?
Also, in Freightshaker's photos there appears to be two leads going to the Load pin. This is pin 87 (lights in Kevin's diagram), yes?
Thanks for all the info and help. I am pretty sure I can get this done, just a little confused about that pin 86 connection.
Greg
|
The two leads (the blue wires) are the wires going to the driving lights. There are two because one is for the left & the other is the right light.
The diagram shows a single wire that is split to two wires going to the two lights, in this case it's easier to just run both to the same terminal.
The lights in this case are the load.