Ok... I was sitting around and I figured ... what the hell... I'll post up some pictures.
This is the finished picture of the side cover... once it cures I'll sand and polish it.
This is how the tail section turned out
I took the top end apart this morning as I mentioned in the previous post... here are the pictures of that.
valve cover is off along with all the tins and coils.
I needed to take the pistons off so that I could take them to be matched up with the bore job(that I didn't end up needing) They come off pretty easy. Just remove a spring clip and the wrist pin slides right out. just don't drop any parts into the block :-0
Always # your pistons so they match back up with the bore... 1-4 from the left.
Ok thats it for today
Rock on Kawi people
Matt-