Replacing wheel bearings on Bayou 220?

dmulc · 10-02-2007

I just picked up a 2001 Bayou 220. I don't have a manual yet.
It needs front wheel bearings. I pulled the wheels but can't get the hubs off. (The brakes are loose from them)
How do the hubs come off?

dmulc · 10-05-2007

They're a standard drum brake hub. They seem like they're just rusted on. I was wondering if anyone had a trick for pulling them. I'm ordering a manual today.

tsankou1 · 2 Weeks Ago

u gotta get the cotter pin out and unscrew the bolt and pry it off with a flathead

fb0226 · 2 Weeks Ago

use a flat head or pry bar, put pressure on the drum and tap with a hammer on the opposite side. then switch sides then alternate 90 deg at a time, till it pops off. key word tap

86klf300guy · 2 Weeks Ago

i had to use a slide hammer to pull my drums off with the brakes de adjusted they were on there pretty good lol but a slide hammer makes easy work of it -corey-

10-02-2007	#1 (permalink)
dmulc Newbie Join Date: Jul 2007 Posts: 2	Replacing wheel bearings on Bayou 220? I just picked up a 2001 Bayou 220. I don't have a manual yet. It needs front wheel bearings. I pulled the wheels but can't get the hubs off. (The brakes are loose from them) How do the hubs come off?

2 Weeks Ago	#4 (permalink)
fb0226 Shade Tree Join Date: Jun 2008 Location: Hills of Ky. Posts: 20	use a flat head or pry bar, put pressure on the drum and tap with a hammer on the opposite side. then switch sides then alternate 90 deg at a time, till it pops off. key word tap __________________ "I can fix anything......except stupidity" 1981 C B 750 Custom 1990 Bayou KLF 300 c

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bayou 220 rear question	blksabth	Kawasaki ATV and Mule	1	09-16-2007 07:10 PM
NEED HELP - Wheel bearings	KDX220(1997)	Kawasaki Motocross and Offroad	8	03-01-2007 03:12 PM
Vulcan 2000 rear wheel bearings...	spokes	Kawasaki Cruisers	12	12-14-2006 01:06 PM
Replacement starter relay/solenoid	therealSnafoo	The Mechanics Corner	13	04-04-2006 09:02 AM
Kawasaki Bayou 220 wheel swap	emory	Kawasaki ATV and Mule	0	12-14-2005 05:51 PM

10-05-2007	#2 (permalink)
dmulc Newbie Join Date: Jul 2007 Posts: 2	They're a standard drum brake hub. They seem like they're just rusted on. I was wondering if anyone had a trick for pulling them. I'm ordering a manual today.

2 Weeks Ago	#3 (permalink)
tsankou1 Newbie Join Date: Aug 2008 Posts: 17	u gotta get the cotter pin out and unscrew the bolt and pry it off with a flathead

2 Weeks Ago	#5 (permalink)
86klf300guy Clutch Cadet BTK Expert Join Date: Feb 2008 Location: some where in ohio Posts: 375	i had to use a slide hammer to pull my drums off with the brakes de adjusted they were on there pretty good lol but a slide hammer makes easy work of it -corey-

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)