repacking muffler question-what to use to wrap packing?

[skater69]

Getting some replacement fiberglass packing.....question what do I use to wrap it around the baffles?
Thx,

[Lattimer]

I have always used masking tape. Holds it in place until you have the baffle back in, and it will burn up harmlessly over time.

[bigjohnyeti]

I wrap mine with masking tape.It`ll hold it all the packing together until the baffle is in place.The tape will char a bit,but it actually doesn`t stink or burn.
John

[skater69]

Thanks, what about electrical tape?

[RichLockyer]

Stinky.

[bigjohnyeti]

Looks like Shawn and I were both typing at the same time ..lol

[bluestringer]

Masking tape. And if you want some packing that last a long time and tones down the pipes a bit, try this.

http://www.motorcycle-superstore.com...662&division=6

[Scruffy]

Go buy some chimney packing. Think asbestos wool... And I use a light wire to hold it in place. Lasts longer than fiberglass and masking tape (which do the job fine, I'm just a lazy cheapskate).
-Scruffy

[Rubline]

I have always used bailing wire. Thin enough not to interfear with anything, but stiff enough not to come apart.

[skater69]

Originally Posted by bluestringer

Masking tape. And if you want some packing that last a long time and tones down the pipes a bit, try this.

http://www.motorcycle-superstore.com...662&division=6

Do you have to buy 2 quantities of those......like one for each pipe?

[elevater]

Wrapped my baffles with galvanized steel roof flashing first the put the old packing back on to hold the baffle in place ( V&H Baggers) changed the tone a bit but not any louder to my ear. The packing should never burn out again
Elevater

[stevebtx12]

I'd use either wire or masking tape and stay away from electrical tape, that would melt, and might ooze out...

[bikeaholic]

wrapped mine in soft taco shells with diced tomatoes and shredded cheese
didnt hold too well but made for a tasty snack..........











sorry-couldnt resist.........have lunchmeat in my shoes and feelin a little funny

[N3TQV]

Originally Posted by skater69

Getting some replacement fiberglass packing.....question what do I use to wrap it around the baffles?
Thx,

I re-wrapped my baffles in my Cobra baggers ( I know, the baffles don't come out of the Cobra baggers, it's a long story) and I used some muffler repair tape from the auto parts store. Soak it in water and then wrap it around the packing. Two or three places, leave lots of space for the glass to show through. It dries real hard and is heat resistant. WHen it comes time to replace, it can be cut with scissors and removed. More expensive than masking tape but it won't burn up. Come to think of it, the masking tape idea sounds pretty good too.
N3TQV