Radiator shroud w/ highway pegs and engine guards?

[ALStensby]

Anyone know if this is possible on a Meanstreak? I love the look of the shroud but obviously would get a practical use out of the engine guard and highway pegs. But, by looking at it, I don't think it can be done. Then again, the highway pegs and guards might look out of place combined with the shroud. Any thoughts?

[streak07]

You could always just get the chin spoiler.

I went with hepco and becker crash guards which wouldn't effect the shroud but they're at the powdercoaters and not installed yet so no pics. They had to be imported from Germany so they took a month to show up and were pricier than others on the market. The chrome quality looked top notch although they'll be powdercoated wet black by next monday. I got them from twistedthrottle.com. I know of no other engine guards that would work without modification due to the bar going across the front of the radiator and using the same bolt location. Maybe someone else knows some that go inside the frame.

[ALStensby]

Thanks for the help, Streak. Oddly enough, after posting i happened across just a chin spoiler. The bike is black so it should work nicely.

[streak07]

Scootworks or lowandmean both have chin spoilers. I prefer lowandmean as theirs is open on the front which would allow more airflow to the bottom half of the engine. Good luck.

[ALStensby]

Open is a good thing. I definitely think I'm going to look more in to that option since it leaves more open for me instead of the full shroud. Eventually, I want that with the reaper front fender and, if I can convince the wife of it, might have someone fabricate a big rear fender to mimic the reaper. But, we'll see. I just can't leave well enough alone.