Kawasaki Motorcycle Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
How do I replace fwd driveshaft universal? The one immediate to Fwd axle differential. :?:
 

·
Registered
Joined
·
1 Posts
hcjp said:
How do I replace fwd driveshaft universal? The one immediate to Fwd axle differential. :?:
Did you get any feedback to this question?
I am about to replace mine and would like to know how it went.
thanks
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
2000 Mule 2510 4x4 FWD driveshaft universal replacement.

I haven't gotten a reply yet? I have already purchased the replacement cross (or spider) but haven't attempted it yet. I was hoping to hear from
Jim at Beartooth Kawasaki who responded to me before. :?
 

·
Registered
Joined
·
10 Posts
frt Ujoint

It is supposed to be easy to put in a ujoint in a mule, I have and it's not a prob. Have you ever put a joint in a drive shaft or ?.
You should get a repaire manual from your dealer it will be a good investment. If there isn't any rust on the pinion shafts all you do is
remove bolts from hanger bearing and any thing that is in way of
slideing hanger over to one side and pull drive shaft from rear diff
than pull shaft apart. Now you can pull the frt part from frt. diff.
Than go to your vise and have at it. Bob
 
1 - 4 of 4 Posts
Top