Kawasaki Motorcycle Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter #1
:lol: Anyone know a method of getting the bar ends off without using impact wrech.Or is this necessary cause them **** screws will not unscrew.Let me know thanks All
 

·
Registered
Joined
·
47 Posts
Discussion Starter #3
Thanks for reply! it is a 94.I havnt tried elctric drill maybe i will that..Thanks again for the info
 

·
Registered
Joined
·
182 Posts
You should not attempt to take off the bar ends... the bartender might get mad! j/k :lol:
 

·
Registered
Joined
·
2,159 Posts
STUCK

I had to use a small torque breaker for some work. It is a small device about the size of a roll of quarters and has diffferent attachments like Phillips, Torx...and then you smack it lightly with a hammer and it turns just a squeek to "Break" it loose. The too yo might try some penetrating oil before you get to heavy into it... You could always put your name and address on a piece of paper and put it inside the bar too...
 
1 - 6 of 6 Posts
Top