Kawasaki Motorcycle Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
set to stock settings, set float height, cleaned carb. wont rev out past idle without using choke circuit.... did notice needle jet doesnt fit tight in carb body, (very loose) i replaced it and if fits same way? warn carb body? not sure how it is supposed to fit...
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top