[medhatken]

Has anyone heard, have or know where to get one? Not that a person really needs one but hey, it would be cool!!:mrgreen:

 

[gillyiowa]

someone checked on it a while back. The v2k.s cylinders can only handle a .040 overbore. Someone would need to cast a whole new cylinder set-up to get any real hp benefit out of it. The stock cylinders are pretty much a throw away item

 

[vn125cn30507]

You can take your cylinders and have a sleeve installed on them and then bore the cylinder to your desired size. I did this and bored my engine .250 over. That made mine 140cid. J&E made me a set of Pistons as well. The only thing is, Piston company's only make a set of 4 so you have to buy 4.

 

[VnBeast]

You can take your cylinders and have a sleeve installed on them and then bore the cylinder to your desired size. I did this and bored my engine .250 over. That made mine 140cid. J&E made me a set of Pistons as well. The only thing is, Piston company's only make a set of 4 so you have to buy 4.

Where did you get the sleeves? Where did you get the work done?