carb question problem on 04 500r

1147 Views 6 Replies 3 Participants Last post by 500r, Sep 17, 2004

500r

Discussion Starter · Sep 17, 2004

I Have a 04 500r And I need to know if anyone can post a picture of were the idle mixture screw is And how do you go about adjusting them I have heard you have to pull the carbs and drill out the plug first. And How do you go about pulling the carbs out do you have to pull the gas tank and all of that Stuff to get to them. Thanks

Save

1 - 1 of 7 Posts

1Adam12

· #6 · Sep 17, 2004

Drain your carbs 1st.

To get the carbs pulled, remove the airbox and tank and you should be able to get at the carbs fairly easy. Loosen up the hose clamps and work the rubber hose off the carbs leaving the rubber hoses attached to the'll have to disconnect the choke and throttle cable along with all the vacuum and fuels hoses attached.

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month