changing sprockets for speed on drifter 800

1 - 1 of 1 Posts

mexico drifter

Registered

Joined Feb 6, 2004

27 Posts

Discussion Starter • #1 • May 20, 2004

I have the opportunity to change my sprockets on my 800 drifter since my chain ate them for lunch. has anybody done this and had good results for top end speed increase? I would love to have the specks if you are willing to share.
VROC#13290

1 - 1 of 1 Posts

Recommended Reading

2008 Concours - Need Local Help (Houston)

The Mechanics Corner

Was involved in an auto accident and bike sat for a few years in the garage. As luck would have it, something (mouse) got to my wirnig harness. Rather than play the splice/test method, I'm looking for someone near or in Houston willing to run a new wiring harness. I'll pay fair price, just...
- 1
- 58
- Challengerbot · updated 1 d ago
ZEPHYR 750 FIRK SAG

The Mechanics Corner

I have a 91 750 Zephyr with only 5.5k on the clock, I know the front end is sloppy on these bikes as standard however I am not looking to upgrade forks or anything like that, I would just like to ensure what I have is set up correctly. Firstly I will swap the fork oil as it potentially could be...
- 9
- 146
- Staff ZR · updated 2 d ago
2006 KFX 400 stalls when coming to a stop

The Mechanics Corner

I've been to every forum out there where someone has asked this same question (or something similar) years ago regarding their 400 stalling when decelerating/breaking and the original poster never came back to say what ultimately fixed the issue. So here we go, I'll be descriptive with the...
- 2
- 2K
- N
  Nate_36 · updated 3 d ago
Valve clearances

The Mechanics Corner

Hi all, In my previous post I asked about weeping oil and got some good answers so thanks to those members who replied, whilst I have the top cover off my 1991 750 zephyr 5k genuine mileage I checked the valve clearances. 6 out of eight were at the loose end of tolerance but one inlet and one...
- 5
- 438
- Staff ZR · updated 3 d ago
#1 cylinder not up to snuff

The Mechanics Corner

I check the exhaust temps on my 85 ZN700 after riding it and the temp of the #1 cylinder exhaust had been getting lower and lower compared to the other 3. I don't ride it that often. So, yesterday I removed the seat and gas tank, removed the idle mix screw, and sprayed carb cleaner down the...
- 1
- 123
- R
  RoadRunner322 · updated 5 d ago