Any one got any ideas on how to get the f**** clutch hub nut off my GPX600 (ZX600C)
The book quotes the use of a Kawasaki clutch holding tool part No 57001-305.
Made equivalent one at work but the nuts on that tight it won’t budge
I need to strip the motor to replace the primary chain and tensioner
Up to this moment a relative easy job just keeps getting harder
Have snapped a stud of getting the exhaust off and now the clutch what else will go wrong
At this rate I’m not going to have any hair left as I keep pulling it out in handfuls
Any ideas would be appreciated
:!:
The book quotes the use of a Kawasaki clutch holding tool part No 57001-305.
Made equivalent one at work but the nuts on that tight it won’t budge
I need to strip the motor to replace the primary chain and tensioner
Up to this moment a relative easy job just keeps getting harder
Have snapped a stud of getting the exhaust off and now the clutch what else will go wrong
At this rate I’m not going to have any hair left as I keep pulling it out in handfuls
Any ideas would be appreciated
:!:
