Kawasaki Motorcycle Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
has anyone else had this problem. i noticed it when you are going slow over a long period of time then you hit the gas hard. it then stumbles a few times , then it's good till you do the same thing. i was wondering if the fuel was boiling out of it or what? :x
 

·
Registered
Joined
·
142 Posts
We have found that the exhaust valves on the 360's are set too tight from the factory. This will cause hard starting, stalling when coming to a hard stop, hesitation in acceleration and loss of power. We spent many hours checking everything from the carbs to timing and that is what we found. Exhaust valve clearance should be from 0.15mm - 0.20mm. I recommend to set it at 0.20mm and that should cure your problem.
 
1 - 2 of 2 Posts
Top