Kawasaki Motorcycle Forums banner
1 - 1 of 1 Posts

10 Posts
Discussion Starter · #1 ·
Hi guys

My KX125 '85 engine rebuild is almost done but I have one problem with gear change mechanism. I didn't took a photo of this mechanism before got it apart (surprise!). Otherwise I have took several photos before getting engine apart.
So I'm not sure how that big spring should be assembled on mechanism. I cannot get it working no matter how I put the spring in there. Can you tell/explain how this should be done? Is that spring in right orientation on my attachment picture?




1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.