Kawasaki Motorcycle Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi i have a 1988 bayou 300.It back fire and then begin to run bad.It starts and idles good but wont rev up it miss fire sound like a bunch of little back fire.I replaced the timing chain,cdi,remove gas from tank and clean carb,clean and set valves,remove exhaust,by pass ignition sw,the timing mark on bottom lines up but the cam shaft sprocket is 2mm off.I dont know what else to do
 

· Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
yea i know what you mean ,i checked the key on the flywheel and its good also i inspect the cam sprocket its good .A guy told me that the crank could have turn on itself were its press together and fire when its not in t.d.c. I was thinking it sound more like the cam shaft.Thank you for replying.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top