Kawasaki Motorcycle Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
My carbs are flooding on my 90' zx-750 no matter how much I clean them. I need to rebuild them or replace the needle and seats. how does the seat come out? is it a rubber seat or is it machined in? were can I get some after market cone air filters to fit on each carb??? how much does a rebuild kit cost? thanks in advance!!!
 

·
Registered
Joined
·
78 Posts
K and N do air filters for almost every bike imagineable
While your on doing your carbs why not put a stage 1 kit in too :D (or mebby even a stage 3)
 

·
Registered
Joined
·
1,384 Posts
Sounds like your float needles are of need in cleaning or being replaced. You can pull the carb apart and check for the float needles. Not likely, but your floats could be bad or need to be adjusted, but if they were working fine before leave them be for now until you trouble shoot a few more things.

Vacuum lines could have issues causing the overflow as well.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #4
What vacuum lines could cause the problem? Do you have a diagram? are my needle seats replacable??? Who sells cheap stage 1 kits?
thanks
 

·
Registered
Joined
·
1,384 Posts
mazdawg1987 said:
are my needle seats replacable??? Who sells cheap stage 1 kits?
thanks
Call our host sponsor for both items. You can also find them on ebay!
 

·
Registered
Joined
·
1,384 Posts
1 - 7 of 7 Posts
Top