Kawasaki Motorcycle Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
folks is it possible to strip down my kz750 1981 E2 speddo etc to clean.. i want to take to bits and clean / paint and reassemble but the units look sealed.. if there seal anyone know any valid replacement parts that would work / look good.

Thanks

Gordon
 

·
Registered
Joined
·
22 Posts
other than the glass being cleaned you can go on ebay and get chrome covers for the complete gauge,i installed them on my 78 kz650c they look great.
 

·
Registered
Joined
·
792 Posts
You can carefully un-crimp the center band that hold the two halves together. It's not an easy task, and you can cause some minor damage if your not careful. You'll want to reuse the center piece to close it all up again, so don't break it.
The covers mentioned above do a good job of covering up mistakes.

 
1 - 4 of 4 Posts
Top