Kawasaki Motorcycle Forums banner
Cancel

Mule 2510-98 model--overheating

17243 Views 5 Replies 4 Participants Last post by  RCW, 
H
I have done everything I can think of to solve this problem-removed thermstat,replaced water pump,checked radiator caps,flushed water system,removed all hoses for inspection,installed temp guage,bled air from system,jumped fan to run constantly. This mule will circulate water just fine for some time then stops, have to bled system-pumps sometimes for couple hundred yards then same thing again. From cold start does good for maybe a mile if you are sure it is circulating then same thing again. Carb. heater was stoped up but have good flow now. HOPE SOMEONE CAN HELP ME ON THIS.
Reply
Save
Like
1 - 1 of 6 Posts
H
Did you actually pull the radiator and have it cleaned at a shop ?
What is actually happening is it blowing coolant out then overheating or is just over heating. if the first is the case you might have compression getting into the cooling system.
Reply
Save
Like
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Kawasaki Motorcycle Forums
A forum community dedicated to Kawasaki Motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, off-road, touring, street bikes, and more!
Full Forum Listing
Explore Our Forums
Kawasaki Cruisers Main Lobby Kawasaki Streetbikes/Sportbikes Vintage Motorcyle Info The Mechanics Corner
Top