Joined
·
4 Posts
Is this a typo mistake on mule brochure? it says the width on a gas Mule 3010 as 57.5 inches. And the width on the diesel Mule 3010 as 56.7?
Mule Brochure
1 - 3 of 3 Posts
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
2003 Bayou 250 reverse
Kawasaki ATV and MuleNew to the group and first time posting. I have a 2003 bayou 250 I purchased recently that runs great but reverse shifting was difficult. The reverse knob would turn more than it should. I tried to adjust the cable with no luck. While replacing the reverse cable with a new one, I noticed how...- 1
- 431
-
2000 kawasaki prairie 400 drive/clutch delay
Kawasaki ATV and Mulei've got a KVF400, 2 wheel drive. runs w/o issue, however, when I give it gas, there is a delay. the motor responds immediately, but the unit doesn't start to move until the motor revs a good bit. once moving, there is very little delay. i pulled the cover off of the clutches, everything is...- 2
- 209
-
Mitch4ut · updated
-
3010 Mule starter issue
Kawasaki ATV and MuleNew to the forum and looking for some advice with my 3010 / gas engine. Never had any issues with it for twelve years except the normal maintenance. Went to start it after not being there for 3 months. Dead battery is what it usually has been. When i bought a new battery and went to install it...- 1
- 318
-
Need pin configuration
Kawasaki ATV and MulePin configuration.fuji.21119-1069...which pins do what? Thanks asap.- 1
- 259
-
Clifford chick · updated
-
2005 Mule 3010 trans governor
Kawasaki ATV and MuleHey guys, new to the forum. I picked up a 2005 mule 3010 a few months ago with only 355 hours. The machine is in excellent shape but i noticed its not going the advertised 25 mph. 20 mph is all it will do. I know its not a speed demon, and I'm not trying to make it one, but i would like it to go...- 1
- 357
Join now to ask and comment!