Kawasaki Motorcycle Forums banner

1 - 2 of 2 Posts

·
Patriot Guard Rider
Joined
·
322 Posts
Discussion Starter · #1 ·
Help! Just got home from the dealership and the right spot and turn assembly is completely loose and rattling around. How do you tighten it up? Don't have the plans on the light bar since it was wired up at the shop. Dealer is closed now for the weekend. Can't ride till it's tightened, afraid the thing will fall off!
 

·
Patriot Guard Rider - PA
Joined
·
326 Posts
In all likelyhood, a deep metric socket (probably a 12 or 14mm) is all you'll need. You'll need to aim the critter when you re-tighten it - use a garage wall or something flat and upright to aim it at.

Unplug the wire, curl the pigtail and stuff it into the socket while slipping it over the light's stud. Aim it, hold that position and tighten the socket down. Remove socket, reattach wires, check alignment.

Repeat as necessary.

Have fun!

ZD
 
1 - 2 of 2 Posts
Top