I am looking for a complete spare rear rim. 2004 KX 500. I don't need a tire. Would like stock bearings, sproket, disk, ect.
E-mail: [email protected]
San Diego, California
E-mail: [email protected]
San Diego, California
need a KX500 rear rim
Join the discussion
Recommended Reading
-
1980 KL250 cdi wiring diagram
Kawasaki Motocross and OffroadHi I am new to this forum and hoping someone can help, I have a long running battle trying to get my 1980 KL 250 running, I purchased the bike rode it home about 20 miles and the next trip out it cut out and wouldn't run again.(a six mile walk later and nearly a year) I am hoping to get this...- 2
- 1K
-
Engine
Kawasaki Motocross and OffroadAfter abit of advice I have a 2013 kx250f and the engine has blown beyond repair does anyone no what engine will fit other than a 2013 engine number is kx250ze006893 thanks- 0
- 165
-
-
85 KX80 clutch problems
Kawasaki Motocross and OffroadI have changed the clutch plates and springs on my kx80. Now, the clutch is very hard and pretty much does nothing for the operation of the bike. I was told to put some slack on the spring bolts to allow space for the pusher bearing to engage the clutch. This is not mentioned in the service...- 15
- 3K
-
1990 kx-125 problems
Kawasaki Motocross and Offroadi have a kx-125 and i had it re-sleved, put a new piston in it, cleaned the carb. when i start it up it runs but it bogs out bf reving out,it starts in 1-2 kicks, also after re-sleeving it the compression is still at 60psi any advice? please help- 6
- 5K
Join now to ask and comment!