I had noticed an oil leak and belt slipping,and I took my ride to the shop, they fixed an oil leak. Well, come to find-out, I have had a bolt missing in the bottom of the cvt cover for who knows how long, maybe since the showroom. Now they want to charge me 150 bucks for a new one. My ride is only 4-5 months old w/80hours on it. Suggestions?
problems with my prarie 360
Join the discussion
Recommended Reading
-
2017 Kawasaki Mule Engine siezed
Kawasaki ATV and MuleI messed up, didn't go through the manual as I should have and put the oil in the transmission case. I know, stupid, very stupid I was in a rush and wasn't paying attention. Ran it without oil for a couple days as we were checking cows then the engine just stopped, after checking the oil I...- 0
- 43
-
DwayneWasHere · updated
-
2013 Kawasaki mule 4010 trans 4x4
Kawasaki ATV and MuleThe rear cylinder is not firing, bought new coil and replaced still is not working. Any advice as to what to check next, read on line could be ECU, but that is $700 so don't want to replace unless I know that's the problem.- 4
- 974
-
2001 Kawasaki Bayou Vapor Lock?
Kawasaki ATV and MuleI have a 2001 Kawasaki Bayou that starts and runs fine. I do a lot of work on a ranch with it. If I am driving slow checking fence or spraying weeds it seems to vapor lock. I can also feel the heat from the exhaust pipe, or engine on my leg. Any thoughts or ideas would be greatly appreciated.- 1
- 412
-
KLF300 Lots of resistance on initial acceleration, feels as if brakes are jammed on but rolls in neutral ok.
Kawasaki ATV and MuleI have just got a KLF300 and it starts well but when you push the accelerator there is lots of resistance and noise before the ATV moves, same in forward or reverse. It feels as if the handbrake is on and then it releases when there is enough power and you start moving, but when you stop the...- 1
- 159
-
CHAZZAMATE · updated
-
Kawasaki 220 bayou probably 90’s. Motor locked up
Kawasaki ATV and MuleSo I was trying to pull start my bayou atv 2wd and all of a sudden the pull start locked up I tried pulling off the pull start covering and turning the motor and it will only turn clockwise and it locks up in the same exact place in the counterclockwise postion. Tried to electric start and it...- 1
- 320
-
Jtrent1854 · updated
Join now to ask and comment!