Radiator Caps
Join the discussion
Recommended Reading
-
1980 kz750 head swap over onto 1984 zn700A1
The Mechanics CornerIve got a 1984 zn700A1 with the #3 plug hole completely wollered beyond a helicoil or timesurt being able to do any justice. But,Ive got a 80 kz750 head sitting on my bench with which I was wondering if its possible to do a head swap putting the 750 head on my 700. Will it work WITHOUT having to...- 9
- 399
-
Wanted. ZN750 ZN700 wiring diagram
The Mechanics CornerLooking for a ZN750 or ZN700 wiring diagram. Have done some internet searches without any luck This is for someone else. I don't have a ZN700/750. Thanks. tags >> 1984 ZN700-A1. ZN750-A1. 1985 ZN700-A2. ZN750-A2. Ltd Shaft. wire.- 5
- 145
-
Kawasaki kx500 problem
The Mechanics CornerI have a 1989 Kawasaki kx500 bought it cleaned carburetor && it had straight 2stroke oil so cleaned it put it on && it gave me hell cranking (HAD) strong compression on kickstart but got it running && it ran perfectly for about a few hours on && off until it started blowing more & more smoke &&...- 2
- 302
-
Jacob Roswell · updated
-
Air Screw O-ring installation
The Mechanics CornerSo I had to install 4 new O-rings for the BS-34 Mikuni carbs in my 1984 ZN-1100. Since the dealer wanted $5.00 per O-ring, I sourced these from McMaster Carr at a cost of 5 cents each. Size is 2.5mm ID x 5.5mm OD and the cross section of the rubber is 1.5mm diameter. The fun began when trying...- 0
- 228
-
1971 Kawasaki F8 Bison 250 Will Not Fire
The Mechanics CornerSo I've had this 1971 F8 Bison 250 for probably about 1.5 years now, went through the engine, new rings, new seals and gaskets, did a leak down check and there are zero air leaks on it. The engine has been in the bike for a while and I'm finally getting around to getting it to a riding point...- 0
- 234
Join now to ask and comment!