Kawasaki Motorcycle Forums banner
1 - 1 of 9 Posts

· Registered
41 Posts
I had to drill holes in the bodywork of my friends 2002 CBR 600 to get the sliders to fit. It's not nearly as scary as it sounds. All you really need is a hole saw, and if you really want it to look clean a rubber or chrome ring of the same size(can probably find something that will work at a hardware store). A word of warning though - Measure twice(at the very least) and cut once.

Good Luck,
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.