Thanks

1 - 1 of 1 Posts

mixery2k

Registered

Joined Jan 19, 2004

12 Posts

Discussion Starter • #1 • Jan 20, 2004

Thank you very much, and I really appreciate your detailed instructions Chris, thank you for putting your time into helping me out. And if it is not of any inconvenience for you, I would really apreciate it if you emailed me the scans from the book, my email is [email protected]

Thank you all!

Jonathan

1 - 1 of 1 Posts

Join the discussion

Recommended Reading

2009 Ninja 250 will not start

The Mechanics Corner

Hello, I purchased a used 2009 Ninja 250r a month ago. It initially had 6k miles on it. I have put 1500 on it since. Since I purchased the machine, it has always just started. On Friday I went to a friends house after work. It started right up per usual. When I went to leave his house, the...
- 7
- 6K
- K
  krypt2nite · updated 5 h ago
Engine swop

The Mechanics Corner

Can I fit a 650 s Vulcan engine into a 2007 650 versus. My engine has a hole in the block.I checked the engine is the same except for power output
- 0
- 37
- G
  Grant Ian Henderson · updated 6 h ago
Kawasaki KX80 Clutch issues...I'M COMPLETELY LOST WITH THIS ONE!

The Mechanics Corner

Hi to the forum members. I use this forum a lot for when my bike breaks...usually on a regular basis. Anyway...the clutch was sticking on my KX 80 (1998) so I removed the cluch, removed and filed the basket groves down, replaced the clutch and reconnected the cable. Now I have no tension on the...
- 2
- 537
- D
  darren50 · updated 1 d ago
1985 Z550 Front Fork Issues

The Mechanics Corner

I have an 85 Z550 which I am playing with. the front fork stanchions are pitted so I bought a new (to me) pair. However when I stripped down the bike I found the replacements were 36mm and the originals were 35mm. Now I have the dilema of whether to source another set of forks or stanchions or...
- 1
- 51
- C
  clockman592 · updated 1 d ago
Part number for VN800 - exhaust nut studs

The Mechanics Corner

I've been pouring over diagrams trying to find this part - the nuts and studs they bolt to on my bike are pretty rusty, so I figured the next time I pull the exhaust off I'll change them. I found the part number for the nuts, but I can't find the stud anywhere. I'm talking about the threaded...
- 6
- 1K
- S
  Sayen · updated 2 d ago