torque settings
1 - 2 of 2 Posts
Joined
·
71 Posts
You don't say what part of the clutch you need settings for !!
Clutch cover bolts...8.8nm...(78 in lbs)
Clutch cover noise damper bolts...5.9nm...(52 in lbs)
Clutch spring bolts...8.8nm...(78 in lbs)
Clutch hub nut...130nm...(98 in lbs)
Clutch cover bolts...8.8nm...(78 in lbs)
Clutch cover noise damper bolts...5.9nm...(52 in lbs)
Clutch spring bolts...8.8nm...(78 in lbs)
Clutch hub nut...130nm...(98 in lbs)
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Engine Favoring One Cylinder
The Mechanics CornerHey guys. I've been in the process of rebuilding and restoring an old 1982 kawasaki kz305, and I've encountered a bit of an issue that I can't quite seem to wrap my head around. So when I plugged in both spark plugs to the boots from the coil and turned the engine over, it was discovered that...- 0
- 28
-
Vulcan 2000 problems
The Mechanics CornerI have a 2006 Vulcan 2000. It has Vance and Hines exhaust and a power commander. The battery recently died and required replacing. I put the new battery in and everything seem to be great. I went approximately 5 days without cranking it. I finally got around to firing it up..it just clicked as...- 45
- 22K
-
WEZMOTO brake lines beware!
The Mechanics CornerI purchased a set of these off ebay and they looked cool enough and the price was right so I pulled the throttle and purchased them. They arrived from England and I got to work to install them. Once I got the old lines off I noticed they had the ends turned the wrong direction and that they were...- 13
- 18K
-
GPz 750 Rod Bearings
The Mechanics CornerHi All: If you look at the Partzilla (or the actual Kawasaki ) web site in search of crank bearings for the '83 GPz 750 you will see that there are multiple part numbers. Three sizes for crank main journals and three sizes for connecting rod big end. 92028/92028A/92028B are the main crank...- 1
- 371
Join now to ask and comment!