Kawasaki Motorcycle Forums banner

1 - 2 of 2 Posts

·
lock up your daughters
Joined
·
1,114 Posts
Discussion Starter #1
Ok, so I have bought these kong pars, basically 1.25" apes. Thus far I have re-wired (used solder and shrink tube). Re-ran fuel line and clutch. I am waiting two pieces that connect the individual caliper brake lines to the main line that goes up to the handle bar. Bars are installed, all electronics work. I installed a set of the ISO grips on the bars. I should get the remaining hardware for the brakes this week.

I have not adjusted anything yet, nor have I bleed the brakes (since their not connected).

Anyone have advise (on the adjustments?) beyond what the manual says?
 
1 - 2 of 2 Posts
Top