Kawasaki Motorcycle Forums banner

1 - 6 of 6 Posts

·
Freshman
Joined
·
628 Posts
Discussion Starter · #1 ·
Hey guys,

I'm looking to get Lowers for my '05 1600. I already have a Cobra lightbar installed, which means not all lowers will fit due to the location of the turn signals.

Does anyone know of lowers that will work in my situation? Anyone have this setup and could offer a suggestion and maybe post a pic?

I posted a pic so you guys have an idea of how I need to clear the turn signals.

Thanks all for the help,

MD
 

·
Registered
Joined
·
167 Posts
Ive seen pics where the person cut a hole in the lowers to allow the back of the sig lite pass through. On this bike, the angle plane of the lowers and the rear protrusion of about 1/4-1/3 of the sig lite interfere with each other. Try this link for non copyrighted patterns by ordinary bikers. Mayby one of these publicly available patterns might help.
Jack and Luzimar's Kawasaki Nomad 1500 - Nomad Lowers
 

·
Freshman
Joined
·
628 Posts
Discussion Starter · #3 ·
Hey DrNo,

That site helps a lot. I was looking for some templates to guide me in my attempt to manufacture a set from plexiglass.

Anyone else have this set-up that can recommended some lowers.

MD
 

·
Registered
Joined
·
1,450 Posts
You may take a look at some H/D lowers, part# 58121-85B


 

·
Freshman
Joined
·
628 Posts
Discussion Starter · #6 ·
The problem with mine, is that the turn signals are located below the spot lights, not off to the sides like yours.

This makes it much harder to find lowers that will work.

Thanks,

MD
 
1 - 6 of 6 Posts
Top