ok...well if anyone has a 636 here and wouldnt mind taking a couple measurements for me, i can figure this out.
I just need the measurements where the subframe meets the main frame (those two mounts on either side of the bike), just the width across the bike for both, then the space between each of them on the same side of the bike.
Im thinking if those mounts are similar, i can just swap the whole 636 subframe on the back of mine, toss on the fairing, and the seats and wire it and be done.... Any thoughts?
I need only the left side carb body for a 2003 zr-7s. I'll take a whole set if you have one but if you have a partial set or a set you can't use that has a good left carb body, that's all I really need.
Looking at bringing back my wife to rider status (she is a qualified rider) and beginning research to find a nice smaller, lighter ride for her.
Presently thinking of a GPZ550 OR a KZ550 OR a Zephyr 550.
Would the forum members be kind enough to share their opinions based on experience with...
Vilken typ av motor har jag och undrar på vilka motorcykel den sitter. Motornumret är F107-101202 125 cc vattenkyld
Vilken typ av motor har jag och undrar på vilken motorcykel den sitter. Motornummer är F107-101202 125 cc vattenkyld
I have a 2001 ZR-7S and would like to know where the center stand rests so it does not contact the chain. I have it rigged up with a stand-off so it does not do this but it rests on the swing arm now. I have a rubber peice mounted on the swing arm to protect it from damage but I don't feel this...
A forum community dedicated to Kawasaki Motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, off-road, touring, street bikes, and more!